If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Is it safe to press teh Elite Synergy XT at the limb tips as I did with my Mathews DXT? I'm currently using the Hydra-Press Elite as that is what I own. Just curiosu as I haven't seen a list of presses that peopel have used on them.
Should be. I am using an EZ-press on an XLR, and an '07 Synergy. I believe somewhere there is a thread which discusses which presses might invalidate the warranty. Faiurly sure the EZ-press and such like were fine.
'09 Ninja XLR 28.25" 57#, Fuse 30" Blade and 12" Blade side rod.
'07 Synergy 28.25".
'06 Energy with Rev Cam.