No announcement yet.

no valley on my Fire, help!

  • Filter
  • Time
  • Show
Clear All
new posts

  • no valley on my Fire, help!

    I have had an issue with my fire since I bought it used. There is hardly any valley at full draw. If I barely let up on tension the string wants to jump out of my hand. I have the #1 mods and have the draw stop moved up all the way to the top. I also put on #2 mods to see if anything would change with those. i still wanted to jump out of my hands. Finally, I put on new factory strings from Elite and the problem still persists.

    Does anyone have an suggestions? Could the timing be off on the cams? I have lost confidence in the bow for hunting purposes because I am afraid its going to want to jump out of my hands when I am drawn on a deer.
    2007 Synergy, STS, 70 lbs

  • #2
    Yes timing is off. It can be in sync but if its out of time it will have a short valley.
    start by syncing the cams at full draw.
    Then check Dl and draw weight. on the cable side where the cables hook to the cable post should have a papers width gap. not touching the cable at rest. check and let us know where yours is at. Your welcome to send a Pm if you like.
    No ifs and or buts Just maybee.