If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have one like it but with the jack attachment on the side. I would not risk using yours without the jack attachment, it is too hard to calculate where to set the rollers and would bend the limbs so they might hit the support arm of the rollers. You can make it a jack style by a little cutting and welding or buy the updated roller with a jack. If I had to do it again, I would get one with jacks on both sides. I have pressed many Elites on mine with success but not later than 2008, but it should work on all of them.
15 Elites - 1 GTO, 3 E-500s, 1 Synergy, 2 SynXTs, 4 Envys, a 2008.5 Z28, 2 2008.5 GT500, a Aigil, Impulse
2 K&K Vengeance , 2011 PSE Axe 6, 2011 Hoyt Carbon Element, Four Tributes and one Allegiance